These accessories and the shotgun have been amazing. I think I have spend more on the add-ons than I have for the shotgun itself which has been rock solid we got first place for a gopher tournament just got 95 of them. I feed all the rejected 12 ga shells thotugh this stuff that has poor crip, over, under crimp, crimps that are opening up and dents bend in the sidewalls of the shells and the shotguns eats them all and spits them out. Highly reccomend and the heat sheild fits perfect dont pay attention to the bad reviews they don't know how to loosen their barrels to install, I don't think there is any instructions but there is a slot for it on the receiver. I love this gun and he addon options got the extended tube ghost sight and heat shield on the two I have friends love them.

great product and looks good on it. im giving a 4 star cause during shooting test. i did have powder residue across the back of it. does not seem like it fits snug

Very nice product. Installed in a few minutes fit great. Nice finish well made part.

Don't know why there are any bad reviews of this heat shield... I pulled the barrel out about 1 inch, slid the front of shield under front sight, lowered the rear of shield down against the barrel and slid everything back in place. Tighten magazine cap and you are done! Literally took less than 5 minutes, Great addition to the Titan!

Arrived right on schedule. I have not had the time to get it installed but so far it looks like it is very good quality! ?

Easy to install, but after installation the barrel does not sit perfectly back to its original position by about almost 1/4”. I Haven’t shot it yet, but I’ll I’m not sure how I like not being able to fully tighten down the magazine cap to its previous position.

Good Quality, only issue was I had to file down the notch at the top so it fit correctly on the barrel

Requires fitting. Better have a file handy.

These are great. Don't listen to the reviews below. These shields fit great. Take the barrel out about 1.5 inches. The front of the shield will slide over the front sight. If it is stiff, wiggle it side to side until it fully slides up under the notch built into the sight. You will know you have it right when the rear of the shield is flush with the recess in the rear of the barrel. You could hit it with a file for easier installation, but you will not have the same lockup when it is finally installed.