Did not fit the TTS,I was hoping it would but no

Looks real nice! Fits good and was easy to put on .

As soon as I took the first shot it came flying off the gun. Nor were there even any instructions on how to install it.

Heat shield fits and functions awesome!! Looks great on shotgun!!

Very easy to install, does not require additional brackets for mounting to the barrel simply snaps in place between the front sight and the front receiver area is very durable steel coated in a good quality finish definitely is helpful when barrel overheats from rapid fire.

Come in useful, for tactical use if you have to grab the barrel you won't burn your hands.

The heat sheild fits fine, here's a few steps for those who need help installing it, 1.remove the tube cap, pull handguard off, loosen the barrel nut enough to slide the barrel out and inch, 2 put the hand guard back on, 3 put the heat shields front end gap under the front sight at an angle then push down near the end of the barrel closes to the reciever, push down hard then slide the barrel back in place you may have to pull the bolt back to full seat it, 3 screw your 2 shell extension or factory tube cap on all the way, 4. Get a screw driver mostly a flat head and then tighten the barrel nut till it dosnt move anynore by moving the flat head agianst the checked texture rotating it, through the mlok holes on the front of the hand guard. Note you may have bent the reciever side of the heat sheild to get a more snug fit.

Quality I 'm very happy with this item thanks guys

I slightly removed the barrel and slide the shield over top and behind the front sight. It was a snug fit, reattaching the hand guard(extra snug fit), with a little bit of elbow grease. Afterwards I was able to reassemble, the little bit I took apart, install the +2 barrel and the rear sight, to complete my customization. Again, this can be done with any modifications. 1.Loosen tube nut & slide the barrel out about an inch 2.Slide behind front sight and fit into the space above the barrel 3. Slide handguard back down into place, 4.retighten all loosened parts: tube cover